INT RUNDOWN CORRECTION LIST REVISED 29 OCTOBER 1971RA

Ответить
auditor
Сообщения: 726
Зарегистрирован: 28 дек 2015, 12:01

INT RUNDOWN CORRECTION LIST REVISED 29 OCTOBER 1971RA

Сообщение auditor »

HUBBARD COMMUNICATIONS OFFICE
Saint Hill Manor, East Grinstead, Sussex
HCO BULLETIN OF 29 OCTOBER 1971RA
Remimeo
Auditors Cl IV and above
C/Ses
Int RD Chksht
Cl IV Grad Chkshts REVISED 14 MAY 1974
RE-REVISED 24 SEPTEMBER 1978

Interiorization Rundown Series 12

INT RUNDOWN CORRECTION LIST
REVISED


PC: ___________________________________ DATE: _________________________________

PC GRADE: ____________________________ AUDITOR: _____________________________

The purpose of this list is to correct an unflat, overrun or otherwise messed up Int RD.
This list is used when:
A) The subject of Int/Ext reads on a repair list and the Int RD has already been run.
B) A bog occurs on the Int RD itself. An L3RG would first be used to detect any Dianetic er-rors.
C) The pc is upset after the Int RD or the End of Endless Int Repair RD, has head somatics, high or low TA, or is not VGIs on the subject of going into things.
NOTE 1: Per HCOB 12 Sep 78, URGENT. IMPORTANT, DIANETICS FORBIDDEN ON CLEARS AND OTs, Dianetic Clears, Clears and OTs are not to be audited on the Int RD as it uses Dianetics. They may be given the End of Endless Int Repair RD as it is a Recall Process.
The following list may be assessed on Dianetic Clears, Clears and OTs, however, as: 1) it also applies to the End of Endless Int Repair RD and 2) the pc may have been run on the Int RD before the above HCOB was issued.
If a Dianetic Clear, Clear or OT reads on any question which calls for a Dianetic handling (Ex: Questions 2, 3, 4, 7, 9, 29) the Dianetic handling is not done. Do NOT engage in any activity that brings about further engram running.
The correct action, if you get a read on one of the above questions, is to indicate it and let the pc tell you about it if he wishes, to bring it to an F/N.
Where the handling calls for an L3RG, an L3RG could be assessed, but you must not do more than indicate the reading questions. You must not engage in engram running.
Otherwise, the handlings given on the Int RD Correction List may be done on Clears and OTs. A Clear or OT who then has any further unresolving Int trouble would be referred to an AO for handling.
NOTE 2: If the pc has had only the End of Endless Int Repair RD do not assess those questions marked with an asterisk (*) (Questions 2, 3, 4, 29) or do any repair action that calls for Dianetics.
_________________

Assess this list Method 3.
Take up each item that reads and get the reading item fully repaired to F/N. Suppress and False can be used as needed to take a question to F/N. Handle each read to F/N. Do not go on to another question leaving one that has not F/Ned.
If at any time while doing the list the pc has a big win with F/N, VGIs, acknowledge, indicate the F/N and end off. Do not take the list beyond a major win for the pc.
R-FACTOR: We are going to do an assessment concerning the subject of interiorization. (If pc does not understand this R-Factor clear up what the Int RD or the End of Endless Int Repair RD was as he may not have recognized it.)
____________

1. On your INT handling is a recall flow unflat? ___________
Assess the following, using the Int button the pc has been run on.
Is recall a time when you (Int button) unflat?
Is recall a time when you caused another (Int button) unflat?
Is recall a time when others caused others (Int button) unflat?
Is recall a time when you caused yourself (Int button) unflat? (Assess on Quad pcs only.)
For Int RD: Flatten the unflat flow(s) to F/N, cog, VGIs. – For End of Endless Int Repair RD: Pick up the unflat flow and handle to four F/Ning flows on that Int button. Then reassess the Int buttons, as the entire RD may not have been flattened and will now need to be.
*2. On your INT RD was a chain or incident left unflat?
Find out which one(s). Handle with an L3RG. ___________
*3. (NOTE: ASSESS No. 3 ONLY ON PCs WHO’VE HAD THE ORIGINAL INT RD, NOT THE REVISED INT RD.)
Is a secondary flow unflat?
L3RG and handle. ___________
*4. Is an engram flow unflat?
L3RG and handle. ___________
5. Was some part of your INT handling misrun?
Find out what. – For Int RD: handle with an L3RG any messed up chains. – For End of Endless Int Repair RD: straighten out any messed up recall flows and handle per No. 1 above. ___________
6. Did you run the concept of ”being in” or ”being stuck in” instead of the concept of ”going in?”
Sort it out. Find out what was run. Handle any confusions. If it is established that he didn’t run the concept of ”going in” on whatever the running button was, check the button for read. If it reads, run the Int RD or End of Endless Int Repair RD properly. Do not run the RD if the button doesn’t read. ___________
7. Were you running an item that was different than the one assessed?
Indicate it. Get the item the pc was actually running and take it to full EP if not yet flat. Then recheck the item that was assessed, put in Suppress and Inval as necessary, and if charged run the item that was assessed (on whichever RD the pc had). ___________
8. Did the INT button assessed have no charge on it?
Indicate the button was uncharged and should not have been run and all actions connected with it should not have been run. D/L if necessary. ___________
9. Was there another INT button that should have read?
Get what it was and note its read as the pc gives it. Find out if the Int button that was taken up instead is charged. If so, complete any handling on it to F/N. If not, handle as in No. 8 above. Then handle the new item, if charged, on Int RD or End of Endless Int Repair RD, whichever applies. ___________
10. On your INT handling were you run on a recall flow that had no charge on it?
Find out which one and indicate that that flow should not have been run. ___________
11. Can’t you get in?
If so, L&N to BD F/N item ”Who or what was afraid to go into things?” Then run alternate repetitively ”What did (item found) do?” ”What did (item found) withhold?” to an F/N and a blow. ___________
12. Do you have an out-list?
Handle with L4BRA. ___________
13. Was the rundown done over an ARC break?
Problem?
Withhold?
Overt?
Indicate and handle to F/N. ___________
14. Was the rundown done over some other bypassed charge?
Find out what and handle. ___________
15. Was the wording of the rundown badly cleared?
Fully clear all MUs to F/N. ___________
16. On your INT handling was there a misunderstood word?
Fully clear all MUs to F/N. ___________
17. Were you confused about something?
Clear it up with the correct references. Itsa E/S itsa to F/N. ___________
18. Didn’t you understand what the RD was for?
Clear this up with correct references. Itsa E/S itsa to F/N. ___________
19. Were you thinking of leaving during INT?
Itsa E/S itsa to F/N. ___________
20. Were you leaving a post?
Itsa E/S itsa to F/N. ___________
21. Were you trying to get a post?
Itsa E/S itsa to F/N. ___________
22. Anything to do with jails?
Itsa E/S itsa to F/N. ___________
23. Are you wanted anywhere?
Itsa E/S itsa to F/N. ___________
24. Are you afraid that if you get out you will cause damage?
Itsa E/S itsa to F/N. ___________
25. Would letting you out be an overt?
Itsa E/S itsa to F/N. ___________
26. Have you failed to get out in an earlier religion or practice?
Itsa E/S itsa to F/N. Note for C/S to handle earlier practices on program. ___________
27. Do you just move back into the body and push against it?
Itsa E/S itsa to F/N. ___________
28. Were there auditor errors?
Indicate. Sort it out and clean up BPC. If R3RA errors, use an L3RG (except for Clears, etc.), L1C if neces-sary. ___________
*29. Were there errors on engrams?
Find out what and handle with an L3RG. ___________
30. (ASSESS ONLY ON DN CLEARS, CLEARS OR OTS.) Were you audited on Dianetics after go-ing Dianetic clear or Scientology Clear?
Indicate that he should not have been run on Dianetics after Clear. If no F/N, D/L when he went Clear. ___________
31. Has INT been neglected for a long time?
Indicate. Itsa E/S itsa to F/N. ___________
32. Are you worried because interiorization continues to read?
Indicate. Itsa E/S itsa to F/N. ___________
33. Are you concerned because you have to be reviewed?
Indicate. Itsa E/S itsa to F/N. ___________
34. Was the INT RD (end of endless INT repair RD) already flat?
Indicate. Date/Locate the flat point. ___________
35. Was your INT handling overrun?
Indicate. Date/Locate the flat point. ___________
36. Was INT handling unnecessary in the first place?
Indicate. If no F/N, Date/Locate the point he felt good about going into things. ___________
37. Did you feel fine about going into things to begin with?
Indicate it. If no F/Ns Date/Locate that point. ___________
38. Is your INT handling perfectly okay?
Indicate. If no F/N, Date/Locate the point he felt good about going into things. ___________
39. Has your INT handling been overrepaired?
Indicate. Date/Locate the flat point. ___________
40. Has INT been run several times over?
Indicate. Date/Locate the flat point. ___________
41. Has the INT RD correction list been overdone?
Indicate. If no F/N Date/Locate the point he felt his Int RD was repaired. ___________
42. On your INT handling did you go past a win?
Indicate. Rehab the win to F/N VGIs. If no F/N, Date/Locate that point. ___________
43. During your INT handling did you go exterior?
Indicate. Rehab to F/N VGIs. If no F/N, Date/Locate that point. ___________
44. Is this action unnecessary?
Indicate. If no F/N itsa E/S itsa to F/N. ___________
45. Is there something else wrong?
Find out what and handle. ___________


L. RON HUBBARD
Founder
LRH:dr
Professional auditing in any place on the planet http://timecops.net/english.html http://0-48.ru https://www.facebook.com/Galactic_Patro ... 206965424/ Auditor class X, skype: timecops
Ответить

Вернуться в «L Ron Hubbard original HCO BULLETINS, POLISIES»